SEFIRE · Fireplace guides
How to Refill a Water Vapor Fireplace: Manual and Automatic Systems
Identify the water system before refilling a mist fireplace. Avoid overfilling, wet electrical parts and applying one model’s procedure to another.

First identify the refill method
Some water vapor fireplaces have a removable or manually filled tank. Others use a pump, hose or automatic supply. Read the delivered model's instructions and locate the approved fill point. Do not pour water into the flame slot, light assembly or body simply because the tank is below it.
Manual-fill planning
Allow any required shutdown and cooling time, isolate power as instructed and protect nearby electrical parts. Use the specified water and filling container. Respect the indicated working level or automatic stop; nominal tank volume is not an instruction to add that volume each time. Refit caps or tanks correctly and dry any spills before reconnecting or restarting the appliance.
Make the opening accessible enough to carry out this procedure without reaching across delicate finishes or lifting the entire unit. A beautiful surround that prevents a tank from being removed is an installation problem.
Automatic supply
Confirm inlet and outlet identification, permitted supply conditions, shutoff and drainage with the appliance instructions and installer. Do not interchange a drain hose and a supply hose. Before leaving a new installation in normal use, the installer should check connections and demonstrate filling, stopping and isolation. Investigate repeated fill errors or leakage; do not keep cycling the unit to force water in.
SEFIRE ranges use different arrangements
Primary VSFB is described in the current catalog with manual fill and drain. Deluxe supports automatic filling and draining, subject to the ordered configuration. Round outdoor ODVF models use their own automatic-fill procedure. For those models, the high-level and low-level water figures are operating reference values, not a measured jug-filling instruction. Follow the automatic stop and the delivered manual.
When the flame effect does not return
- Check that the tank is seated and the level meets the instructions.
- Check any model-specific error indication.
- Confirm that the water source and cleaning condition are suitable.
- Look for a trapped, disconnected or incorrectly routed hose.
- Stop and request service if leakage, electrical smell or repeated errors occur.
Do not bypass a level sensor, run an atomizer dry or add unapproved chemicals. Include the model, error display and photos of the water connection in a service request.